1068 Captive Portal Commands
Default Configuration
Configurations are enabled by default
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#no enable
group
Use the group command to configure the group number for a captive portal
configuration. If a group number is configured, the user entry (Local or
RADIUS) must be configured with the same name and the group to
authenticate to this captive portal instance. Use the “no” form of this
command to reset the group number to the default.
Syntax
group
group-number
no group
•
group-number
—The number of the group to associate with this
configuration (Range: 1–10).
Default Configuration
The default group number is 1.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
To Next Page
Loading...
