Dell PowerConnect 6224 - User Password

1084 Captive Portal Commands
User Guidelines
There are no user guidelines.
Example
console(config-CP)#user 1 name johnsmith
user password
Use the user password command to create a local user or change the password
for an existing user.
Syntax
user user-id password { password | encrypted enc-password }
• user-id —User ID (Range: 1–128).
•
password —User password (Range: 8–64 characters).
•
enc-password —User password in encrypted form.
Default Configuration
There are no users configured by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(Config-CP)#user 1 password
Enter password (8 to 64 characters): ********
Re-enter password: ********