178 Using the CLI
gets you up and running as quickly as possible. You
can skip the setup
wizard, and enter CLI mode to manually configure the
switch. You must
respond to the next question to run the setup wizard
within 60 seconds,
otherwise the system will continue with normal
operation using the default
system configuration.Note: You can exit the setup
wizard at any point
by entering [ctrl+z].
Would you like to run the setup wizard (you must
answer this question within
60 seconds)? [Y/N] n
Thank you for using Dell Easy Set up Wizard. You will
now enter CLI mode.
Applying Global configuration, please wait ...
Applying Interface configuration, please wait ...
console>
console>
console>
console>show switch
Management Preconfig Plugged-in
Switch Code
To Next Page
Loading...
