Using the CLI 185
• Option To Activate the Backup Image. This option determines the
active image and toggle the bootloader to use the backup image.
[Boot Menu] 11
Backup image - image1 activated.
• Option to use the password recovery procedure. It allows the switch to
boot one time without prompting for a console password. Note that the
‘enable’ password is not prompted for in this mode.
[Boot Menu] 12
Monitoring Traps from CLI
It is possible to connect to the CLI session and monitor the events or faults
that are being sent as traps from the system. This feature is equivalent to the
alarm-monitoring window in a typical network management system. The user
enables events or monitor traps from the CLI by entering the command
logging console. Traps generated by the system are dumped to all CLI
sessions that have requested monitoring mode to be enabled. The no logging
console command disables trap monitoring for the session. By default,
console logging is enabled.
To Next Page
Loading...
