Dell PowerConnect 6224 - Page 234

234 Address Table Commands
show ports security addresses
Use the show ports security addresses command in Privileged EXEC mode to
display current dynamic addresses in locked ports.
Syntax
show ports security addresses {ethernet interface |port-channel port-channel-
number
}
• interface — Valid Ethernet port
•
port-channel-number — Valid port-channel number
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Examples
The following example displays dynamic addresses for port channel number
1/g1.
Status The status can be one of the following: Locked
or Unlocked.
Actions Action on violations.
Maximum The maximum addresses that can be associated
on this port in Static Learning mode or in
Dynamic Learning mode.
Trap Indicates if traps would be sent in case of
violation.
Frequency The minimum time between consecutive traps.
Field Description