Dynamic ARP Inspection Commands 279
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08
show ip arp inspection ethernet
Use the show ip arp inspection ethernet command to display the Dynamic
ARP Inspection configuration on all the DAI enabled interfaces. Giving an
interface argument, it displays the values for that interface.
Syntax
show ip arp inspection ethernet [
interface
]
•
interface
— Valid Ethernet port. The full syntax is unit/port.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC
User Guidelines
The following fields are displayed for each interface:
Interface The interface-id for each displayed row.
Trust State Whether interface is trusted or untrusted for DAI.
Rate Limit The configured rate limit value in packets per second.
Burst Interval The configured burst interval value in seconds.
To Next Page
Loading...
