280 Dynamic ARP Inspection Commands
Example
console#show ip arp inspection ethernet
Interface Trust State Rate Limit Burst
Interval
(pps) (seconds)
--------------- ----------- ---------- ---------
------
1/g1 Untrusted 15
1
1/g2 Untrusted 10
10
show ip arp inspection statistics
Use the show ip arp inspection statistics command to display the statistics of
the ARP packets processed by Dynamic ARP Inspection. Given vlan-range
argument, it displays the statistics on all DAI enabled Vlans in that range. In
the case of no argument, it lists the summary of the forwarded and dropped
ARP packets.
Syntax
show ip arp inspection statistics [vlan
vlan-range
]
•
vlan-range
—A valid VLAN range.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
To Next Page
Loading...
