IP Addressing Commands 363
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#no ipv6 enable
ipv6 gateway
Use the ipv6 gateway command to configure an IPv6 gateway for the
management interface. Use the "no" form of this command to reset the
gateway to the default.
Syntax
ipv6 gateway
gateway-address
no ipv6 gateway
gateway-address
—The gateway address in IPv6 global or link-local address
format.
Default Configuration
There is no IPv6 gateway configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 gateway 2003::1
console(config)#no ipv6 gateway
To Next Page
Loading...
