Dell PowerConnect 6224 - Page 509

RADIUS Commands 509
radius-server retransmit
Use the radius-server retransmit command in Global Configuration mode to
specify the number of times the Radius client will retransmit requests to the
Radius server. To reset the default configuration, use the no form of this
command.
Syntax
radius-server retransmit retries
no radius-server retransmit
• retries — Specifies the retransmit value. (Range: 1–10)
Default Configuration
The default is 3 attempts.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the number of times the Radius client
attempts to retransmit requests to the Radius server to 5 attempts.
console(config)#radius-server retransmit 5
radius-server source-ip
Use the radius-server source-ip command in Global Configuration mode to
specify the source IP address used for communication with Radius servers. To
return to the default, use the no form of this command. 0.0.0.0 is interpreted
as a request to use the IP address of the outgoing IP interface.
Syntax
radius-server source-ip source