Dell PowerConnect 6224 - Page 511

RADIUS Commands 511
User Guidelines
This command has no user guidelines.
Example
The following example sets the interval for which a switch waits for a server
host to reply to 5 seconds.
console(config)#radius-server timeout 5
retransmit
Use the retransmit command in Radius mode to specify the number of times
the Radius client retransmits requests to the Radius server.
Syntax
retransmit retries
• retries — Specifies the retransmit value. (Range: 1-10 attempts)
Default Configuration
The default number for attempts is 3.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before
executing this command.
Example
The following example of the retransmit command specifies five retries.
console(config)#radius-server host 192.143.120.123
console(config-radius)#retransmit 5