Voice VLAN Commands 613
•
trust—
Trust the dot1p priority or DSCP values contained in packets
arriving on the voice vlan port.
•
untrust—
Do not trust the dot1p priority or DSCP values contained in
packets arriving on the voice vlan port.
•dscp
—
The DSCP value (Range: 0–64).
Default Configuration
The default DSCP value is 46.
Command Mode
Interface Configuration (Ethernet) mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-1/g1)#voice vlan 1
console(config-if-1/g1)#voice vlan dot1p 1
console(config-if-1/g1)#voice vlan none
console(config-if-1/g1)#voice vlan untagged
voice vlan data priority
This command is to either trust or not trust (untrust) the data traffic arriving
on the voice VLAN port.
Syntax
voice vlan data priority { trust | untrust }
•
trust—
Trust the dot1p priority or DSCP values contained in packets
arriving on the voice vlan port.
•
untrust—
Do not trust the dot1p priority or DSCP values contained in
packets arriving on the voice vlan port.
To Next Page
Loading...
