802.1x Commands 623
User Guidelines
This command has no user guidelines.
Example
The following command manually initiates a re-authentication of the 802.1x-
enabled port.
console# dot1x re-authenticate ethernet 1/g16
dot1x re-authentication
Use the dot1x re-authentication command in Interface Configuration mode
to enable periodic re-authentication of the client. To return to the default
setting, use the no form of this command.
Syntax
dot1x re-authentication
no dot1x re-authentication
Default Configuration
Periodic re-authentication is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables periodic re-authentication of the client.
console(config)# interface ethernet 1/g16
console(config-if-1/g16)# dot1x re-authentication
To Next Page
Loading...
