IPv6 Multicast Commands 763
show ipv6 pimsm rphash
Use the show ipv6 pimsm rphash command to display which rendezvous
point (RP) is being selected for a specified group.
Syntax
show ipv6 pimsm rphash
group-address
group-address
—Group IP address supported by RP.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 pimsm rphash ff1e::/64
RP Type
Address
------------------------ -----
3001::1 BSR
show ipv6 pimsm rp mapping
Use the show ipv6 pimsm rp mapping command to display all group-to-RP
mappings of which the router is aware (either configured or learned from the
bootstrap router (BSR)). If no RP is specified, all active RPs are displayed
To Next Page
Loading...
