786 IPv6 Routing Commands
Example
The following example suppresses router advertisement transmission.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd suppress-ra
ipv6 pimdm
Use the ipv6 pimdm command to enable PIM-DM Multicast Routing Mode
across the router in global configuration mode or on a specific routing
interface in interface mode. Use the “no” form of this command to disable
PIM-DM.
Syntax
ipv6 pimdm
no ipv6 pimdm
Default Configuration
IPv6 PIM-DM is disabled by default.
Command Mode
Global Configuration mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 pimdm
ipv6 pimdm hello-interval
The ipv6 pimdm hello-interval command is used to configure the PIM-DM
Hello Interval for the specified router interface. The Hello-interval is to be
specified in seconds. Use the "no" form of this command to reset the hello
interval to the default.
To Next Page
Loading...
