IPv6 Routing Commands 787
Syntax
ipv6 pimdm hello-interval
interval
no ipv6 pimdm hello-interval
• interval - The hello interval time in seconds (Range: 0–65535).
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan5)#ipv6 pimdm hello-interval
500
ipv6 route
Use the ipv6 route command in Global Configuration mode to configure an
IPv6 static route.
Syntax
ipv6 route
ipv6-prefix
/
prefix-length
[Null | interface {tunnel
tunnel-id
|
vlan
vlan-id
}]
next-hop-address
[
preference
]
no ipv6 route
ipv6-prefix
/
prefix-length
[Null | interface {tunnel
tunnel-id
|
vlan
vlan-id
}]
next-hop-address
•
ipv6-prefix
— Is the IPv6 network that is the destination of the static
route.
•
prefix-length
— Is the length of the IPv6 prefix — a decimal value (usually
0-64) that shows how many of the high-order contiguous bits of the
address comprise the prefix (the network portion of the address). A slash
mark must precede it.
To Next Page
Loading...
