Dell PowerConnect 6224 - Page 991

OSPFv3 Commands 991
Syntax
show ipv6 ospf virtual-link areaid neighbor
• areaid — Identifies the OSPF area whose virtual interface information is
being displayed.
•
neighbor — Router ID of neighbor.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 1 and its neighbor.
console#show ipv6 ospf virtual-link 1 1.1.1.1
Area ID........................................ 1
Neighbor Router ID.............................
1.1.1.1
Hello Interval................................. 10
Dead Interval.................................. 40
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State..........................................
point-to-point
Metric......................................... 10
Neighbor State................................. Full