256 Configuring System Information
Figure 6-114. Stack Port Summary
The Stack Port Summary page contains the following fields:
•
Unit
— ID number of the unit.
•
Interface —
Identifies the stack interface assigned to the unit.
•
Configured Stack Mode
— Indicates whether or not each unit is able to participate in the stack.
•
Running Stack Mode
— Indicates whether or not each unit is actually participating in the stack.
•
Link Status
— Indicates whether or not the stack interface for each unit is operating.
•
Link Speed (Gb/s)
— Indicates the nominal speed of each unit’s link.
Viewing Stack Port Summary Using CLI Commands
For information about the CLI commands that perform this function, see the
System Management
Commands
chapter in the CLI Reference Guide. The following table summarizes the equivalent CLI
commands you use to view Stack Port information.
Stack Port Counters
Use the Stack Port Counters page to view the transmitted and received statistics, including data rate and
error rate.
To display the Stack Port Counters page, click System
→
Stacking
→
Stack Point Counters in the tree
view.
Table 6-55. Stack Port Commands
CLI Command Description
stack-port Configures ports as either stack ports, or as Ethernet ports.
show stack-port Displays summary stack-port information for all interfaces.
To Next Page
Loading...
