444 Configuring Switching Information
Figure 7-111. Dynamic ARP Inspection Rule Configuration
The Dynamic ARP Inspection Rule Configuration page contains the following fields:
•
ARP ACL Name
— Select the ARP ACL for which information is to be displayed or configured.
•
Sender IP Address
— To create a new rule for the selected ARP ACL, enter in this field the Sender IP
Address match value for the ARP ACL.
•
Sender MAC Address
— To create a new rule for the selected ARP ACL, enter in this field the Sender
MAC Address match value for the ARP ACL.
Displaying the DAI ACL Rule Summary Table
1.
Open the
DAI ACL Rule Configuration
page.
2.
Click
Show All
.
The
Dynamic ARP Inspection ACL Rule Summary
table displays.
Figure 7-112. Dynamic ARP Inspection Rule Summary
Configuring Dynamic ARP Inspection Rule With CLI Commands
For information about the CLI commands that perform this function, refer to the following chapter in
the
CLI Reference Guide
:
• Dynamic ARP Inspection Commands
To Next Page
Loading...
