604 Configuring Routing
The Loopback ID field goes away, and the remaining loopback fields display.
Figure 9-56. Loopbacks Configuration - IPv4 Entry
5.
Enter
IPv4
in the
Protocol
field.
6.
Enter desired values in the remaining fields.
7.
Click
Submit
.
The new loopback is saved, and the webpage reappears showing secondary address configuration fields.
Figure 9-57. Loopback Configuration - Add Secondary Address
8.
Complete the
Secondary Address
,
Secondary IP Address
, and
Secondary Subnet Mask
fields.
9.
Click the
Add Secondary
button. The secondary address is saved, and the webpage reappears showing
the primary and secondary loopback addresses.
To Next Page
Loading...
