Dell PowerConnect 6224 - Page 711

Configuring Quality of Service 711
Viewing the Auto VoIP Summary Table
1. Open the Auto VoIP Interface Configuration page.
2. Click Show All .
The
Auto VoIP Summary page opens.
Figure 11-23. Auto VoIP Summary
Configuring Auto VoIP Interfaces Using CLI Commands
For information about the CLI commands that perform this function, see the following chapter in the
CLI Reference Guide:
• QoS Commands
The following table summarizes the equivalent CLI commands for this feature.
Table 11-12. AutoVoIP Interface Commands
CLI Command Description
switchport voice detect auto Enables the VoIP Profile on all the specified interface.
show switchport voice Displays the status of auto-voip on an interface or all interfaces.