Dell PowerConnect 8024 - Show Stack-Port Diag

1084 System Management Commands
Example
The following example displays information about the summary stack-port counters.
console#show stack-port counters
---------------------TX-------------- ----------RX--------------
Data Error Data Error
Rate Rate Total Rate Rate Total
Unit Interface (Mb/s) (Errors/s) Errors (Mb/s) Errors/s) Error
s
------------------------------------------------------------------
-
1xg100 000 0
1xg200 000 0
1xg300 000 0
1xg400 000 0
The following table describes the fields in the example.
show stack-port diag
NOTE: This command is intended only for Field Application Engineers (FAE) and developers. An FAE will
advise when to run this command and capture this information.
Field Description
Unit Unit
Interface Port
Tx Data Rate Transmit data rate in megabits per second on the stacking
port.
Tx Error Rate Platform-specific number of transmit errors per second.
Rx Data Rate Receive data rate in megabits per second on the stacking
port.
Rx Error Rate Platform-specific number of receive errors per second.
Rx Total Errors Platform-specific number of total receive errors since
power-up.