Dell PowerConnect 8024 - Dot1 X Timeout Re-Authperiod

802.1X Commands 533
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
• seconds — Time in seconds that the switch remains in the quiet state following a failed
authentication exchange with the client. (Range: 0–65535 seconds)
Default Configuration
The switch remains in the quiet state for 60 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
During the quiet period, the switch does not accept or initiate any authentication requests.
Change the default value of this command only to adjust for unusual circumstances, such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
To provide a faster response time to the user, enter a smaller number than the default.
Example
The following example sets the number of seconds that the switch remains in the quiet state
following a failed authentication exchange to 3600.
console(config)# interface ethernet 1/g16
console(config-if-1/g16)# dot1x timeout quiet-period 3600
dot1x timeout re-authperiod
Use the dot1x timeout re-authperiod command in Interface Configuration mode to set the
number of seconds between re-authentication attempts. To return to the default setting, use the
no form of this command.
Syntax
dot1x timeout re-authperiod seconds
no dot1x timeout re-authperiod
• seconds — Number of seconds between re-authentication attempts. (Range:
300–4294967295)