646 IPv6 Multicast Commands
ipv6 pimsm register-threshold
Use the ipv6 pimsm register-threshold command to configure the Register Threshold rate for
the RP router to switch to the shortest path. Use the "no" form of this command to set the
register threshold rate to the default.
Syntax
ipv6 pimsm register-threshold
threshold
no ipv6 pimsm register-threshold
• threshold—The threshold rate (Range: 0–2000 Kbps).
Default Configuration
The default threshold rate is 0.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm register-threshold 250
ipv6 pimsm rp-address
Use the ipv6 pimsm rp-address command to statically configure the RP address for one or more
multicast groups. The optional keyword override indicates that if there is a conflict, the RP
configured with this command prevails over the RP learned by BSR. Use the "no" form of this
command to remove the RP address for one or more multicast groups.
Syntax
ipv6 pimsm rp-address
rp-address group-address/prefixlength
[ override ]
no ipv6 pimsm rp-address
•
rp-address
—An RP address.
•
group-address
—The group address to display.
•
prefixlength
—This parameter specifies the prefix length of the IP address for the media
gateway. (Range: 1–32)
To Next Page
Loading...
