Dell PowerConnect 8024 - Ipv6 Ospf Transmit-Delay

806 OSPFv3 Commands
• seconds — The number of seconds between link-state advertisement retransmissions for
adjacencies belonging to this router interface. This value is also used when retransmitting
database description and link-state request packets. (Range: 0 to 3600 seconds)
Default Configuration
5 seconds is the default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF retransmit interval at 100 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf retransmit-interval 100
ipv6 ospf transmit-delay
Use the ipv6 ospf transmit-delay command in Interface Configuration mode to set the OSPF
Transmit Delay for the specified interface.
Syntax
ipv6 ospf transmit-delay seconds
no ipv6 ospf transmit-delay
• seconds — OSPF transmit delay for the specified interface. In addition, it sets the estimated
number of seconds it takes to transmit a link state update packet over this interface. (Range: 1
to 3600 seconds)
Default Configuration
No default value.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.