Dell PowerConnect 8024 - Http Port; Enable

884 Captive Portal Commands
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#captive-portal
console(config-CP)#
enable
Use the enable command to globally enable captive portal. Use the “no” form of this command
to globally disable captive portal.
Syntax
enable
no enable
Default Configuration
Captive Portal is disabled by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#enable
http port
Use the http port command to configure an additional HTTP port for captive portal to monitor.
Use the “no” form of this command to remove the additional HTTP port from monitoring.
Syntax
http port port-num