Dell PowerConnect B-RX - Displaying TACACS and TACACS+ Statistics and Configuration Information

BigIron RX Series Configuration Guide 97
53-1002253-01
Configuring TACACS and TACACS+ security
4
Syntax: ip tacacs source-interface ethernet <portnum> | loopback <num> | ve <num>
The <num> parameter is a loopback interface or virtual interface number. If you specify an
Ethernet, the <portnum> is the port’s number (including the slot number, if you are configuring a
device).
Displaying TACACS and TACACS+ statistics and
configuration information
The show aaa command displays information about all TACACS+ and RADIUS servers identified on
the device.
Syntax: show aaa
The following table describes the TACACS and TACACS+ information displayed by the show aaa
command.
TABLE 37 Output of the show aaa command for TACACS and TACACS+
Field Description
Tacacs+ key The setting configured with the tacacs-server key command. At the Super User
privilege level, the actual text of the key is displayed. At the other privilege levels, a
string of periods (....) is displayed instead of the text.
Tacacs+ retries The setting configured with the tacacs-server retransmit command.
Tacacs+ timeout The setting configured with the tacacs-server timeout command.
Tacacs+ dead-time The setting configured with the tacacs-server dead-time command.
BigIron RX# show aaa
Tacacs+ key: brocade
Tacacs+ retries: 1
Tacacs+ timeout: 15 seconds
Tacacs+ dead-time: 3 minutes
Tacacs+ Server: 207.95.6.90 Port:49:
opens=6 closes=3 timeouts=3 errors=0
packets in=4 packets out=4
no connection
Radius key: networks
Radius retries: 3
Radius timeout: 3 seconds
Radius dead-time: 3 minutes
Radius Server: 207.95.6.90 Auth Port=1645 Acct Port=1646:
opens=2 closes=1 timeouts=1 errors=0
packets in=1 packets out=4
no connection