Dell PowerConnect B-RX - Page 26

xxvi BigIron RX Series Configuration Guide
53-1002253-01
Configuring IPv4 address family route parameters . . . . . . . . . . . .880
Changing the metric style . . . . . . . . . . . . . . . . . . . . . . . . . . . . .880
Changing the maximum number of load sharing paths . . . . .880
Enabling advertisement of a default route . . . . . . . . . . . . . . .880
Changing the administrative distance for IPv4 IS-IS . . . . . . . .881
Configuring summary addresses . . . . . . . . . . . . . . . . . . . . . . .882
Redistributing routes into IPv4 IS-IS . . . . . . . . . . . . . . . . . . . . .883
Changing the default redistribution metric . . . . . . . . . . . . . . .883
Redistributing static IPv4 routes into IPv4 IS-IS. . . . . . . . . . . .884
Redistributing directly connected routes into IPv4 IS-IS . . . . .884
Redistributing RIP routes into IPv4 IS-IS . . . . . . . . . . . . . . . . .885
Redistributing OSPF routes into IPv4 IS-IS. . . . . . . . . . . . . . . .885
Redistributing BGP4+ routes into IPv4 IS-IS . . . . . . . . . . . . . .885
Redistributing IPv4 IS-IS routes within IPv4 IS-IS . . . . . . . . . .886
Configuring ISIS properties on an interface . . . . . . . . . . . . . . . . . .886
Disabling and enabling IS-IS on an interface. . . . . . . . . . . . . .886
Disabling or re-enabling formation of adjacencies . . . . . . . . .886
Setting the priority for designated IS election . . . . . . . . . . . . .887
Limiting access to adjacencies with a neighbor . . . . . . . . . . .887
Changing the IS-IS level on an interface . . . . . . . . . . . . . . . . .888
Disabling and enabling hello padding on an interface . . . . . .888
Changing the hello interval . . . . . . . . . . . . . . . . . . . . . . . . . . . .888
Changing the hello multiplier . . . . . . . . . . . . . . . . . . . . . . . . . .889
Changing the metric added to advertised routes . . . . . . . . . .889
Displaying IPv4 IS-IS information . . . . . . . . . . . . . . . . . . . . . . . . . . .890
Displaying the IS-IS configuration in the running-config . . . . .890
Displaying the name mappings. . . . . . . . . . . . . . . . . . . . . . . . .890
Displaying neighbor information . . . . . . . . . . . . . . . . . . . . . . . .891
Displaying IS-IS Syslog messages . . . . . . . . . . . . . . . . . . . . . . .892
Displaying interface information . . . . . . . . . . . . . . . . . . . . . . . .893
Displaying route information . . . . . . . . . . . . . . . . . . . . . . . . . . .896
Displaying LSP database entries . . . . . . . . . . . . . . . . . . . . . . .897
Displaying traffic statistics . . . . . . . . . . . . . . . . . . . . . . . . . . . .900
Displaying error statistics . . . . . . . . . . . . . . . . . . . . . . . . . . . . .901
Clearing IS-IS information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .902
Chapter 29 BiDirectional Forwarding Detection (BFD)
Configuring BFD parameters . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .905
Number of BFD sessions supported. . . . . . . . . . . . . . . . . . . . .906
Disabling BFD Syslog messages. . . . . . . . . . . . . . . . . . . . . . . .906
Displaying Bidirectional Forwarding Detection information . . . . . .906
Displaying BFD information on a router . . . . . . . . . . . . . . . . . .906
Clearing BFD neighbor sessions . . . . . . . . . . . . . . . . . . . . . . . .910
Configuring BFD for the specified protocol . . . . . . . . . . . . . . . . . . .911
Configuring BFD for OSPFv2 . . . . . . . . . . . . . . . . . . . . . . . . . . .911
Configuring BFD for OSPFv3 . . . . . . . . . . . . . . . . . . . . . . . . . . .911
Configuring BFD for IS-IS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .912