322 BigIron RX Series Configuration Guide
53-1002253-01
Displaying VLAN information
11
Displaying VLAN information
Enter the following command at any CLI level.
Syntax: show vlan [<vlan-id>] [| [begin <expression> | exclude <expression> | include
<expression>]
Enter a VLAN ID if you want to display information for a specific VLAN.
The output shows the following information.
Displaying VLAN information for specific ports
To determine which VLANs a port is a member of, enter the following command.
Syntax: show vlan ethernet <slot-number>/<port-number> [| [begin <expression> | exclude
<expression> | include <expression>]
TABLE 67 Output of show vlan
This field... Displays...
Configured PORT-VLAN entries Number of port-based VLANs in the configuration.
Maximum PORT-VLAN entries: 4095 Maximum number of port-based VLANs that you can configure. Note
however, IDs 4091 and 4092 are reserved for control purposes.
Default PORT-VLAN id ID of the default VLAN.
PORT-VLAN ID of the port-based VLAN
Name Name of the port-based VLAN. [None] appears if a name has not been
assigned.
Priority Level Priority level assigned to the port-based VLAN
L2 protocols Layer 2 control protocol configured on the VLAN
Untagged/Tagged Ports ID of the untagged or tagged ports that are members of the VLAN
(protocol-based VLANs) If protocol based VLANs are configured, their type and name appear
after the list of ports.
BigIron RX# show vlan
Configured PORT-VLAN entries: 3
Maximum PORT-VLAN entries: 4095
Default PORT-VLAN id: 1
PORT-VLAN 1, Name DEFAULT-VLAN, Priority Level0
L2 protocols : NONE
Untagged Ports : ethe 2/1 to 2/24 ethe 3/1 to 3/24 eth
PORT-VLAN 2, Name [None], Priority Level0
L2 protocols : NONE
ip-protocol VLAN, Dynamic port disabled
Name: basic
PORT-VLAN 1001, Name [None], Priority Level0
L2 protocols : MRP
Tagged Ports : ethe 3/1 ethe 3/12 to 3/13 ethe 3/24
BigIron RX# show vlan e 4/1
Port 4/1 is a member of 2 VLANs
VLANs 1 100
To Next Page
Loading...
