Dell PowerEdge 2650 - Installing the System in the Rack; Figure

Rack Installation Guide 1-11
Figure 1-6. Installing the VersaRails Slide Assemblies
Installing the System in the Rack
CAUTION: If you are installing more than one system, install the first system in
the lowest available position in the rack.
CAUTION: Never pull more than one component out of the rack at a time.
1
Pull the two slide assemblies out of the rack until they lock in the fully extended
position.
CAUTION: Because of the size and weight of the system, never attempt to install
the system in the slide assemblies by yourself.
2
Lift the system into position in front of the extended slides (see Figure 1-7).
front of rack
slide assembly (2)
10-32 x 0.5-inch
flange-head Phillips
screw (4 per slide
assembly)
mounting-bracket
flange