1-12 Rack Installation Guide
www.dell.com | support.dell.com
3 Place one hand on the front-bottom of the system and the other hand on the back-
bottom of the system.
4 Tilt the back of the system down while aligning the back shoulder screws on the sides
of the system with the back slots on the slide assemblies.
5 Engage the back shoulder screws into their slots.
Figure 1-7. Installing the System in the Rack (RapidRails or
VersaRails)
shoulder screw on
system
system release
latch (yellow)
slide release
latch (green)
To Next Page
Loading...
