Dell PowerEdge 2650 - Page 31

Rack Installation Guide 1-25
Figure 1-16. Rotating the Front Mounting Bracket for Flush-Mount
Installation
6
Repeat steps 4 and 5 to configure the other slide assembly.
7 Holding the left slide assembly into position in the two-post rack at the location you
marked, adjust the extended back bracket tightly against the vertical two-post rack and
secure it with three 12-24 x 0.5-inch pan-head Phillips screws (see Figure 1-17).
8 Secure the front bracket on the slide assembly to the two-post rail with two
12-24 x 0.5- inch pan-head Phillips screws (see Figure 1-17).
9 Perform steps 7 and 8 to install the right slide assembly in the rack.
10 Use an 11/32-inch wrench or nut driver to fully tighten the nuts on the mounting
brackets on both slide assemblies that you tightened with your fingers.
11 Install the stiffening bracket between the back ends of the slide assemblies and secure
the bracket with a 12-24 0.5-inch pan-head Phillips screw on each slide assembly (see
Figure 1-17).
nut (2 per bracket)
mounting flange
12-24 x 0.5-inch pan-head Phillips screws
(remove 2 per bracket)
NOTE: These screws are shown reinstalled
on the other slide assembly.
1
2
-
2
4
x
0
.
5
-
i
n
c
h
p
a
n
-
h
e
a
d
P
h
i
l
l
i
p
s
s
c
r
e
w
s
(
i
n
s
t
a
l
l
2
p
e
r
b
r
a
c
k
e
t
)
shoulder washer
(2 per bracket)