Information Update 17
Figure 1-3. SAS/SATA Backplane Board Removal
4
If present, disconnect the optical drive power cable from the SAS/SATA
backplane board. See Figure 1-4 for the location of the optical drive power
connector.
5
Disconnect the SAS cable(s) from the backplane connectors.
See Figure 1-4 for the location of the SAS cable connectors.
6
If an optical drive is installed, disconnect the data cable from the back
of the optical drive.
7
If present, remove the storage controller daughter card. See "Removing
a SAS Controller Daughter Card" in your
Hardware Owner’s Manual
.
1 drive carrier 2 SAS backplane board
3 SAS-backplane board release pin
3
1
2
To Next Page
Loading...
