Figure 71. removing a SSD drive blank
Installing an E3.s drive blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
Steps
Insert the drive blank into the drive slot until the release button clicks into place.
Figure 72. Installing the E3.s drive blank
Removing the drive carrier
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Using the management software, prepare the drive for removal.
If the drive is online, the green activity or fault indicator blinks while the drive is powering off. When the drive indicators are
off, the drive is ready for removal. For more information, see the documentation for the storage controller.
Installing and removing system components
69
To Next Page
Loading...
