Dell PowerEdge FC640 - iDRAC Direct LED Indicator Codes; Locating the Service Tag

iDRAC Direct LED indicator codes
The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
You can congure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. The
following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 4. iDRAC Direct LED indicator codes
iDRAC Direct LED
indicator code
Condition
Solid green for two seconds Indicates that the laptop or tablet is connected.
Flashing green (on for two
seconds and o for two
seconds)
Indicates that the laptop or tablet connected is recognized.
Turns o Indicates that the laptop or tablet is unplugged.
Locating the Service Tag of your system
You can identify your system using the unique Express Service Code and Service Tag. The service tag information is available on a sticker
on the chassis of the system. This information is used by Dell EMC personnel to route support calls to the appropriate personnel.
The following image displays a sample service tag, which is available as a sticker on the side of the system.
Figure 3. Sample Service Tag
The following image displays a sample iDRAC MAC address label, which is available as a sticker on the side of the system.
Figure 4. Sample iDRAC MAC address
10
PowerEdge FC640 system overview