Dell PowerEdge FC640 - Installing the rSPI Card

Next step
Install the rSPI card.
Related link
Removing the system board
Installing the rSPI card
Installing the rSPI card
Prerequisite
Follow the safety guidelines listed in Safety instructions.
CAUTION: To prevent damage to the rSPI card, you must hold the card only by its edges.
Steps
1 Align the screw hole on the rSPI card with the stando on the system board.
2 Using the Torx #4 screwdriver, replace the screw to secure the rSPI card to the system board.
Figure 52. Installing the rSPI card
Next steps
1 Install the system board.
2 Follow the procedure listed in After working inside your system.
Related link
Installing the rSPI card
Installing the system board
100
Installing and removing system components