Dell PowerEdge FC640 - Initial System Setup and Configuration; Setting Up Your System; iDRAC Configuration; Options to Set Up iDRAC IP Address

Initial system setup and conguration
Setting up your system
Complete the following steps to set up your system:
1 Unpack the system.
2 Remove the I/O connector cover from the system connectors.
CAUTION: While installing the system, ensure that it is properly aligned with the slot on the enclosure to prevent
damage to the system connectors.
3 Install the system in the enclosure.
4 Turn on the enclosure.
NOTE: Wait for the chassis to initialize before you press the power button.
5 Press the power button on the system.
Alternatively, you can also turn on the system by using:
• The system iDRAC. For more information, see the Log in to iDRAC section.
• The enclosure Chassis Management Controller (CMC), after the system iDRAC is congured on the CMC. For more information,
see the CMC User’s Guide at Dell.com/cmcmanuals.
Related link
Log in to iDRAC
iDRAC conguration
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve the overall
availability of Dell systems. iDRAC alerts administrators to system issues, helps them perform remote system management, and reduces the
need for physical access to the system.
Options to set up iDRAC IP address
You must congure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC.
You must use the default iDRAC IP address 192.168.0.120 to congure the initial network settings, including setting up DHCP or a static IP
for iDRAC. You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings
utility
See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
Dell Deployment
Toolkit
See Dell Deployment Toolkit User’s Guide at Dell.com/openmanagemanuals
Dell Lifecycle
Controller
See Dell Lifecycle Controller User’s Guide at Dell.com/idracmanuals
4
20 Initial system setup and conguration