Figure 28. Removing the processor and heat sink module
Next step
1 Install the PHM.
Related link
Installing a processor and heat sink module
Removing the processor from the processor and heat sink
module
Prerequisites
WARNING
: The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat sink to
cool before removing it.
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the air shroud.
4 Remove the processor and heat sink module.
Steps
1 Insert a at blade screwdriver into the release slot marked with a yellow label. Rotate (do not pry) the screwdriver to break the thermal
paste seal.
2 Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Installing and removing system components
73
To Next Page
Loading...
