Removing the storage controller card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions.
2 Follow the procedure listed in Before working inside your system.
3 Remove the following:
a Drives
b Drive backplane
c Drive cage
Steps
1 Using the Phillips #2 screwdriver, loosen the retention screws on the drive cable connector and lift it away from the storage controller
card.
CAUTION: To prevent damage to the storage controller card, you must hold the card only by its edges.
2 Lift the storage controller card away from the system.
Figure 39. Removing the storage controller card
Next step
Install the storage controller card.
Related link
Removing the drive backplane
Removing a drive carrier
Removing the drive cage
Installing the storage controller card
Installing and removing system components
83
To Next Page
Loading...
