Dell PowerEdge FC640 - Optional Internal USB Memory Key

Figure 44. Installing the system battery
Next steps
1 Install the following:
a Drive backplane
b Air shroud
c Drives
2 Follow the procedure listed in After working inside your system.
3 Enter the System Setup to conrm that the battery is operating properly.
4 Enter the correct time and date in the System Setup's Time and Date elds.
5 Exit the System Setup.
6 To test the newly installed battery, remove the system from the enclosure, for at least an hour.
7 Reinstall the system into the enclosure, after an hour.
8 Enter the System Setup and if the time and date are still incorrect, see the Getting help section.
Related link
Getting help
Removing the drive backplane
Removing a drive carrier
Removing the air shroud
Installing the drive backplane
Installing a drive carrier
Installing the air shroud
Optional internal USB memory key
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. To boot from
the USB memory key, congure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in
System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE
: To locate the internal USB port on the system board, see the System board jumpers and connectors section.
Related link
System board jumpers and connectors
88
Installing and removing system components