Steps
1 Orient the system board toward the front of the system by holding the system board holder and I/O connector cover.
Figure 49. Installing the system board
2 Align the USB connectors with the slots on the front of the system until the connectors engage with the slots.
3 Lower the system board and install the screws to secure the system board to the system, by using Hex nut driver-5 mm and Phillips
#2 screwdrivers.
Next steps
1 Install the following:
a Internal USB key
b micro SD vFlash card
c IDSDM
d Network Daughter Card
e PCIe mezzanine card(s)
f Storage controller card
g Drive cage
h Drive backplane
i Drives
NOTE
: Ensure that you reinstall the drives in their original locations.
j Air shroud
k Memory modules
Installing and removing system components
95
To Next Page
Loading...
