Removing the optional rSPI card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: You must remove the rSPI card to replace a faulty rSPI card or service other components
inside the system.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the #2 Phillips screwdriver ready.
Steps
1. Remove the two screws securing the rSPI card to the system board.
CAUTION: To prevent damage to the rSPI card, hold the card only by its edges.
2. Lift the card away from the system.
Figure 32. Removing the rSPI card
1. screw (2) 2. rSPI card
3. standoff (2) 4. connector
Next steps
1. Install the rSPI card.
100
To Next Page
Loading...
