Dell PowerEdge M1000e - 10 Gb Ethernet I;O Interoperability

setsysinfo
Description Sets the name or location of the chassis.
To run this subcommand, you must have the Administrator privilege.
NOTE: The special characters “ (double quotation mark), ‘ (backward quotation mark), &
(ampersand), and \ (backward slash) are not supported for this subcommand.
Synopsis
racadm setsysinfo -c chassisname|chassislocation <string>
Input
• <string> — Indicates a maximum of 64 nonextended ASCII chassis name or location.
• -c — Sets the chassis name or location.
Example
• racadm setsysinfo -c chassisname "Dell Rack System"
The chassis name was set successfully
• racadm setsysinfo -c chassislocation chassislocation2
Sets Chassis location.
sshpkauth
Description Enables you to upload and manage up to 4 dierent SSH public keys for each user. You can upload a key le or
key text, view keys, or delete keys.
This command has three mutually exclusive modes determined by the options — upload, view, and
delete.
To run this subcommand, you must have Congure user privilege.
NOTE:
• For DSA keys greater than 2048, use the following racadm command:
racadm -r 192.168.8.14 -u root -p calvin sshpkauth -i svcacct -k 1 -p
0xfff -f dsa_2048.pub
• CMC accepts RSA keys up to key strength 4096, but the recommended key strength is 1024.
Synopsis
• racadm sshpkauth -i svcacct -k <key_index> -p <privilege> -t <PK_key_text>
• racadm sshpkauth -i svcacct -k <key_index> -p <privilege> -f <PK_key_text>
• racadm sshpkauth -v -i svcacct -k all|<key_index>
• racadm sshpkauth -d -i svcacct -k all|<key_index>
Input
• -i <user_index> — Index for the user, it must be svcacct for CMC.
• -k [<key_index> | all] — Index to assign the PK key being uploaded. all only works with the -v
or -d options. <key_index> must be between 1 to 6 or all on CMC.
• -p <privilege> — Level to give to user for this PK key.
• -r <cmcIpAddr> — Species the controller’s remote IP address.
• -u <username> — Species the user name.
• -t <PK_Key_Text> — Key text for the SSH Public key.
• -f <filename> — File containing the key text to upload.
NOTE: The -f option is not supported on Telnet or SSH or serial RACADM.
• -v — View the key text for the index provided.
• -d — Delete the key for the index provided.
71