Figure 23. Replacing an SD card
a. IDSDM card
b. SD card
Figure 24. Installing an SD card
a. IDSDM card
b. SD card
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. Enter the System Setup and ensure that the Internal SD Card Port and Internal SD Card Redundancy mode is enabled.
3. Check if the new SD card is functioning properly. If the problem persists, see the Getting help section.
Related References
Getting help on page 133
Safety instructions on page 51
Related tasks
Before working inside your system on page 51
Troubleshooting an Internal SD Card on page 130
After working inside your system on page 52
74
Installing and removing server module components
To Next Page
Loading...
