4. Rotate the carrier handle to the closed position while pushing the carrier into the slot until it locks into place.
The status LED indicator displays a steady green light if the drive is installed correctly. The drive carrier LED green indicator flashes as
the drive rebuilds.
Figure 44. Installing a hard drive
1. release button 2. hard drive(on backplane)
3. hard drive 4. hard drive carrier handle
Figure 45. Installing an SSD
a. release button
b. SSD
c. SSD carrier handle
Next steps
Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
96
Installing and removing server module components
To Next Page
Loading...
