Next steps
1. Install the hard drive or SSD.
2. Follow the procedure listed in the After working inside your system section.
Related References
Safety instructions on page 51
Related tasks
Installing a hard drive or SSD on page 95
Installing a hard drive or SSD blank
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove a hard drive or SSD.
Steps
Insert the hard-drive or SSD blank into the hard drive or SSD slot until the release latch clicks into place.
Figure 48. Installing a 2.5-inch hard-drive blank
a. hard drive or SSD blank
b. release latch
98
Installing and removing server module components
To Next Page
Loading...
