Dell PowerEdge R200 - Entering the BMC Setup Module; BMC Setup Module Options

50 Using the System Setup Program
For additional information on using BMC, see the documentation for the BMC
and systems management applications.
Entering the BMC Setup Module
1 Turn on or restart your system.
2 Press < Ctrl-E > when prompted after POST.
If your operating system begins to load before you press <
Crtl-E >,
allow the system to finish booting, and then restart your system and try
again.
BMC Setup Module Options
For information about the BMC Setup Module options and how to configure
the emergency management port (EMP), see the
BMC User’s Guide .
book.book Page 50 Thursday, August 30, 2007 3:30 PM