Dell PowerEdge R230 - Installing the System Board

Figure 84. Removing the system board
1
touch point (2) 2 system board
Next steps
1 Install the system board.
2 Follow the procedure listed in the After working inside your system section.
Related links
Removing the cooling shroud
Removing a memory module
Removing the expansion card riser
Removing the optional iDRAC port card
Removing the heat sink
Removing the processor
Installing the system board
Prerequisites
CAUTION
: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be performed only by Dell certied
service technicians.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
128 Installing and removing system components