Dell PowerEdge R300 - Page 43

About Your System 43
Warning! No micro
code update loaded
for processor
n
Microcode update failed. Update the BIOS firmware.
See "Getting Help" on
page 167.
Warning! Detected
missing RAID
hardware for the
embedded RAID
subsystem.
RAID key or RAID DIMM
missing when system is in
RAID mode.
Information only.
Warning! Detected
mode change from
SCSI to RAID on
channel x of the
embedded RAID
subsystem.
Embedded RAID
subsystem configuration
has changed in System
Setup.
See "Using the System Setup
Program" on page 48.
Warning! Detected
mode change from
RAID to SCSI on
channel x of the
embedded RAID
subsystem.
Embedded RAID
subsystem configuration
has changed in System
Setup.
See "Using the System Setup
Program" on page 48.
Warning! Embedded
RAID firmware is
not present.
Embedded RAID
firmware does not
respond.
See "Using the System Setup
Program" on page 48.
Warning! Embedded
RAID error!
Embedded RAID
firmware responds with an
error.
See "Using the System Setup
Program" on page 48.
Table 1-7. System Messages (continued)
Message Causes Corrective Actions
book.book Page 43 Sunday, June 21, 2009 5:16 PM