Dell PowerEdge R330 - Ports and connectors specifications; Video specifications

Ports and connectors specications
USB ports
The PowerEdge R330 system supports:
• USB 2.0-compliant ports on the front panel
• USB 3.0-compliant ports on the back panel
• USB 3.0-compliant internal port
The following table provides more information about the USB specications:
Table 15. USB specications
System Front panel Back panel Internal
PowerEdge R330 Two 4-pin, USB 2.0-compliant
ports
Two 9-pin, USB 3.0-compliant
port
One 9-pin, USB 3.0-compliant
port
NIC ports
The PowerEdge R330 system supports two 10/100/1000 Mbps Network Interface Controller (NIC) ports on the back panel.
iDRAC8
The PowerEdge R330 system supports one optional dedicated 1 GbE Ethernet on the iDRAC Enterprise port card.
Serial connector
The serial connector connects a serial device to the system. The PowerEdge R330 system supports one serial connector on the
back panel, which is a 9-pin connector, Data Terminal Equipment (DTE), 16550-compliant.
VGA ports
The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The PowerEdge R330 system supports
two 15-pin VGA ports one each on the front and back panels.
SD vFlash
The PowerEdge R330 system supports one optional SD vFlash memory card on the iDRAC Enterprise port card.
NOTE: The card slot is available for use only if the iDRAC8 Enterprise license is installed on your system.
Internal Dual SD Module
The PowerEdge R330 system supports two optional ash memory card slots with an internal dual SD module.
NOTE: One card slot is dedicated for redundancy.
Video specications
The PowerEdge R330 system supports Integrated Matrox G200 with iDRAC8 and 16 MB application memory.
27