106 Installing System Components
1
Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2
Open the system. See "Opening the System" on page 87.
3
If applicable, remove the cooling shroud. See "Removing the Cooling
Shroud" on page 90.
4
Disconnect the fan’s power cable from the system board. See Figure 3-16.
NOTE: To remove fans 3 and 4, remove the storage controller card first.
See "Removing the Storage Controller Card" on page 129.
NOTE: To remove fan 5 in the twelve–hard-drive systems, remove the internal
hard drive bay and carrier. See "Removing an Internal Hard Drive Bay" on
page 99.
5
Press the release tab while grasping the ends of the fan and lift the fan
straight up from the fan bracket. See Figure 3-15 and Figure 3-16.
book.book Page 106 Friday, November 20, 2009 2:56 PM
To Next Page
Loading...
